1" Snap Lock Trim can be made to your specifications. Call us for
details.
Item | Length | Girth | Gauge | Description |
![]() Ridge |
10'-21' |
13 6/8" |
26 |
Used to cap the intersections of a roof at the peak. Can be used for gable or hip roofs. |
![]() Hip |
10'-21' |
10" |
26 |
Used at hip connections of a roof when something smaller than a ridge cap is desired as in smaller structures. |
![]() Valley |
10'-21' |
20" |
26 |
Used to flash valley connection.The valley lip helps to divert water if it reaches the top of the valley. |
![]() W Valley |
10'-21' |
20" |
26 |
Used to flash valley connections. The center rib helps slow the velocity of water entering the valley. |
![]() W Valley w/wings |
10'-21' |
20" |
26 |
Gives maximum protection in a valley of a roof. The center ridge slows down the velocity of the water while the upper wing keeps water from getting past the top of the valley. |
![]() Zee Closure |
10'-21' |
N/A |
26 |
Zees are used in conjunction with ridge, hip, rake, end wall, side wall, and high side trims to give them something to fasten to on top of the panel. |
![]() Valley Cleat |
10'-21' |
4" |
26 |
This cleat is used to hold valleys in place under the panels. |
![]() Starter Trim |
10'-21' |
4 1/2" |
26 |
Can be used at the bottom of the panel to secure the panel to the decking. |
![]() Offset Plate |
10'-21' |
3 1/2" |
26 |
When an extended eave is not used at the eave this can be used to fasten to the decking and hem the panel to. |
![]() Perimeter Cleat |
10'-21' |
2" |
26 |
This is used in conjunction with rake, eave, high side, and parapet caps to prevent the use of thru fastened screws. |
![]() Eave |
10'-21' |
8 1/8" |
26 |
Used at the eave of the building to flash the facia and to help protect against water that comes from the end of the panel. |
![]() Rake |
10'-21' |
9 1/2" |
26 |
Installed at the gable end of a structure to help hold down the panel as well as prevent water from blowing under the roof panels at the gable end. |
![]() Endwall |
10'-21' |
10" |
26 |
Flashes the area between the wall and the panel where the panel runs perpendicular to the wall. Please specify the pitch of the |
![]() Sidewall |
10'-21' |
10" |
26 |
Flashes the area between the wall and the panel where the panel horizontal to the wall. |
![]() Transition |
10'-21' |
12" |
26 |
Used where two roofs meet to flash the changes in pitch such as a where a porch connects to a main roof. |
![]() Extended Eave |
10'-21' |
8" |
26 |
Used at the eave of the structure and features a projection for panel support as well as something to hem the panel to. |
![]() High Side Trim |
10'-21' |
10" |
26 |
Used at the top of a shed type roof to keep water from blowing in underneath the panels. |
![]() Fascia Trim |
10'-21' |
N/A |
26 |
Used to apply to the fascia board for cosmetic reasons as well as to protect against water. |